ECOLAB SMARTPOWER RTU Dispenser Bedienungsanleitung Seite 100

Servicing and maintenance
3.
Press the retaining rings onto the plug-in couplings
water pipes
4.
Remove the system separator
5. Loosen the screw on the holder and remove the system separator.
ð The system separator is removed.
6. Pay particular attention to the following during installation:
n Push the clean water pipes into the plug-in couplings until you hear a click.
Only then insert the system separator with holder into the unit and screw it into
n
place.
MAN054127 Ver. 01-06.2024
in the direction of the arrow.
4
with holder
1
42
and disconnect the clean
3
from the unit.
5