ECOLAB SMARTPOWER RTU Dispenser Bedienungsanleitung Seite 88

Assembly and connection
3. Use two spanners to tighten the braided steel pipe.
Connecting the product outlet pipe
Personnel:
Protective equipment:
Requirements
n The unit is mounted in accordance with the regulations.
Fig. 5: Product drain pipe connection
1. Attach the hose clamp to the product drain pipe
2. Attach the flexible product drain pipe to the product outlet and lead it into the sink
.
4
3. Slide the hose clamp over the product outlet and tighten it.
4. Attach the protective cap to the spring band of the hose clamp.
If necessary, fasten the product drain pipe so that it cannot slip out of the sink.
MAN054127 Ver. 01-06.2024
If necessary, use the supplied T-connector to connect the steel braided
cable to the connection cable of another SMARTPOWER
Dispenser.
n Service Personnel
n Qualified employee
n Protective gloves
n Safety shoes
Protective eyewear
n
4
3
Product outlet pipe
3
Product outlet
4
.
3
30
TM
RTU