Other Symbols In This Documentation; Units Of Measurement; Safety; Intended Use - STIEBEL ELTRON HSBB 3 S Bedienung Und Installation

OPERATION

Safety

1.3

Other symbols in this documentation

Note
General information is identified by the adjacent symbol.
f Read this information carefully. f
Symbol Meaning
Material losses
!
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
f This symbol indicates that you have to do something. The ac- f
tion you need to take is described step by step.
1.4

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
2. Safety
2.1

Intended use

The appliance is intended to be used for heating interiors and
domestic hot water.
This appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in a non-do-
mestic environment, e.g. in a small business, as long as it is used
in the same way.
f Observe the application limits listed in chapter "Specifica- f
tion / Data table".
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
28 | HSBB 3
2.2

General safety instructions

WARNING Injury
!
The appliance may be used by children aged 8 and older
and persons with reduced physical, sensory or mental
capabilities or a lack of experience and know-how, pro-
vided that they are supervised or they have been in-
structed on how to use the appliance safely and have
understood the resulting risks. Children must never play
with the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they are
supervised.
WARNING Injury
!
f For safety reasons, only operate the appliance with f
the casing closed.
- Only qualified contractors may carry out the electrical work
and installation of this appliance.
- The qualified contractor is responsible for adherence to
all currently applicable regulations during installation and
commissioning.
- Operate the appliance only when fully installed and with all
safety equipment fitted.
- Protect the appliance from dust and dirt ingress during
building work.
- The DHW cylinder is at mains water pressure. If no dia-
phragm expansion vessel is installed, expansion water may
drip from the safety valve during heat-up.
- If water still drips from the safety valve after heat-up, call a
qualified contractor.
2.3

Test symbols

See type plate on the appliance.
3.

Appliance compatibility

The appliance can be operated in conjunction with the following
air | water heat pumps:
- WPL 13 E
- WPL 10 I
- WPL 10 AC (S)
- WPL 15-25 AC (S)
- WPL 08-22 (S) Trend
www.stiebel-eltron.com