Automatic Operation - Hitachi Ras-5101Ch Servicehandbuch

AUTOMATIC OPERATION
Press the FUNCTION selector so that the display indicates
the © (AUTO) mode of operation. Z
@ When AUTO has been selected, the device will auto-
matically determine the mode of operation, HEAT,
COOL, or Dehumidify, depending on the current room
temperature.
@ The FAN SPEED selector does not work at this time: the
FAN SPEED is AUTO during HEAT and COOL, and
LOW during DEHUMIDIFY.
Press the © (START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
(START)
\sToP/
ll As the settings are stored in memory in the remote controller,
you only have to press the O(START/STOP) button next time.
You can raise or lower the temperature setting as necessary by
a madmum of 3°C.
Press and the temperature setting will change
by 1°C each time.
@ The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
@ The display does not indicate the preset temperature in the
AUTO mode. If you change the setting, the cooling unit will
produce a beep.
| Orolatotiirelamey mel Colenr-li(eme)el-le-1elele
: : HI at start, MED or LOW
Over 27°C =p COOL 27°C after the preset temperature
is reached
; HI at start, MED or LOW
Under 23°C after the preset temperature
is reached
Slightly lower than the
room temperature
HEAT
me