Assembly & Use; Opening The Hopper; Closing The Hopper; Installing The Wheel Guards - Burley Hopper Bedienungs- Und Sicherheitsanleitung

Opening the Hopper

1
Lift each support to raise
the Hopper frame.
cHEcK tHAt tHE SuPPortS ArE ProPErLY LocKEd Into PLAcE BEForE uSInG tHE HoPPEr.

Closing the Hopper

1
remove any cargo and any
Press the release button
installed Burley accessories.
then squeeze each yellow
Ensure towbar is not
button
installed in the handlebar
flat to floor of the Hopper.
receiver (see section
"removing Handlebar).
WARNING
cArE MuSt BE tAKEn WHEn FoLdInG And
unFoLdInG to PrEVEnt FInGEr EntrAPMEnt.
HoPPEr
2
continue to raise supports into
a fully vertical position.
WARNING
2
A
to release and fold
B
ENG
3
Lock the supports to the frame
by clicking into place.
A
B
DEU FRA ESP

Installing the Wheel Guards

1
Insert the the wheel guard into the reciever. Slide the
wheel guard back until you hear it click into place.
repeat for other side.
Attaching & Removing
the Wheels
1
While pressing the rubber For removing wheel:
button, insert wheel axle while pressing the
into axle receiver, and button, slide wheel out
then release the button. of the axle receiver.
Pull firmly on wheel to release button.
confirm the axle is fully
engaged.
ASSEMBLY & uSE
2
9