Attaching the Accessories
Mount the nozzle on the spray pipe
(markings on the adjustment ring at the
top).
Connect ray tube to hand spray gun
Lever out the safety clip of the hand
spray gun using a screw-driver (Picture
A).
Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
Press the safety clip back into the hand-
spray gun. The hose can be pulled out
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has
been installed wrongly (picture C).
In devices without hose drum:
Loosen the clamps of the pushing han-
dle.
Adjust the handle to the desired height.
Tighten the clamps of the pushing han-
dle.
Fasten the high pressure hose to the
high pressure connection.
In devices without hose drum:
Insert the crank in the hose drum shaft
and lock it in.
Before rolling up, stretch out the high
pressure hose.
Wind the high pressure hose in uniform
layers on the hose drum by rotating the
crank. Select the rotation direction in
such a way that the high pressure hose
does not get bent.
Electrical connection
Danger
Danger of injury by electric shock.
–
The appliance may only be connected
–
to an electrical supply which has been
installed in accordance with IEC 60364.
The voltage indicated on the type plate
–
must correspond to the voltage of the
electrical source.
The minimum fuse rating required at the
–
socket outlet is (see technical specifica-
tions).
The appliance should always be con-
–
nected to the electrical mains using a
plug. It is forbidden to permanently con-
nect the appliance to the power supply.
The plug is only for mains separation.
Check the power cord with mains plug
–
for damage before every use. If the
power cord is damaged, please arrange
immediately for the exchange by an au-
thorized customer service or a skilled
electrician.
The plug and coupling of the extension
–
cable used must be watertight.
Use the extension cord that has an ad-
–
equate cross-section (see "Technical
Data") and unwind it fully from the cable
drum.
Unsuitable electrical extension cables
–
can be hazardous. Only use electrical
extension cables outdoors which have
been approved and labelled for this pur-
pose and have an adequate cable
cross-section:
For connection values, see type plate/tech-
nical data.
– 3
EN
Start up
19