Attaching The Accessories; Start Up; Electrical Connection; Water Connection - Kärcher HD 10/15-4 F Originalbetriebsanleitung

Attaching the Accessories

 Mount the nozzle onto the spray pipe.
Tighten covering nut firmly.
 Connect ray tube to hand spray gun
 Fasten the high pressure hose to the
high pressure connection.

Start up

Electrical connection

Warning
The appliance may only be connected
–
to an electrical supply which has been
installed in accordance with IEC 60364.
The voltage indicated on the type plate
–
must correspond to the voltage of the
electrical source.
The minimum fuse rating required at the
–
socket outlet is (see technical specifica-
tions).
The appliance should always be con-
–
nected to the electrical mains using a
plug. It is forbidden to permanently con-
nect the appliance to the power supply.
The plug is only for mains separation.
Check the power cord with mains plug
–
for damage before every use. If the
power cord is damaged, please arrange
immediately for the exchange by an au-
thorized customer service or a skilled
electrician.
The plug and coupling of the extension
–
cable used must be watertight.
Use the extension cord that has an ad-
–
equate cross-section (see "Technical
Data") and unwind it fully from the cable
drum.
Unsuitable extension cables can be
–
hazardous. Only use extension cables
outdoors which have been approved for
this purpose and labelled with a suffi-
cient cable cross section:
For connection values, see type plate/tech-
nical data.

Water connection

Connection to the water supply
Warning
Observe regulations of water supplier.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
For connection values refer to technical
specifications
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 1") to
the water connection point of the appli-
ance (such as the tap).
Note
The supply hose is not included.
 Open the water supply.
 Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
 Switch off the appliance and fit the noz-
zle again.
– 3
EN 13