Before Startup; Attaching The Accessories - Kärcher K 7 Originalbetriebsanleitung

7 Storage for trigger gun
8 Transport handle
9 Plug 'n' Clean detergent bottle with
locking lid
10 Storage of Plug 'n' Clean detergent bot-
tle with detergent connection
11 Storage for high pressure hose
12 Storage for spray lance
13 Storage hook for mains connection ca-
ble
14 Mains cable with mains plug
15 Bearing wheel
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high pressure hose
from the trigger gun
19 High pressure hose
20 Spray lance with pressure regulation
(Vario Power)
Carrying out the most common cleaning
tasks. The work pressure can be stage-
lessly regulated between "Min" and
"Max". You can add detergent when
"Mix" is selected.
In order to adjust the working pressure,
release the lever of the hand spray gun
and turn the spray lance to the desired
position.
21 Spray lance with Dirtblaster
For strong contaminations
———————————————–
Optional accessories
22 Washing brush
Suitable for use with detergents.
23 Delta-Racer D150
The Delta-Racer combines a wash brush
with a rotating high pressure jet. There-
fore, it is especially suited for vehicle
cleaning or heavily soiled surfaces.
24 Foam nozzle with detergent container
With powerful foam for effortless clean-
ing.
———————————————–
Not included in the delivery
25 Water supply hose
Use a fabric reinforced water hose with
a commercially available coupling. Min-
imum diameter 13 mm (1/2 inch); mini-
mum length 7.5 m.
18
All manuals and user guides at all-guides.com
Illustrations on fold-out
pages!
Mount loose parts delivered with appliance
prior to start-up.
Install the storage for trigger gun
Illustration
 Place the bottom holder into the recess-
Illustration
 Insert the top holder and push down all
Install the storage hook for the mains
connection cable
Illustration
 Press in the storage hook and lock it
Install the dosage regulator for
detergent
You will need the 2 included screws as well
as a Phillips screwdriver PH 2.
Illustration
 Insert both detergent hoses onto the
 Install the dosage regulator and con-
Install the transport handle
Illustration
 Attach the transport handle, insert the
Connect the high pressure hose to the
trigger gun
Illustration
 Push the high pressure hose into the
– 8
EN

Before Startup

Attaching the Accessories

es and push forward until it audibly
locks in.
the way.
into the top position.
hose fittings.
nect using 2 screws.
Note: During installation you must
make sure that the tongues of the dos-
age regulator match up with the intend-
ed recesses in the casing.
bolts into the bores and screw them in.
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high pressure hose.