Setting - P.lindberg Roth Dps-175 Bedienungsanleitung

SETTING

The mowing height depends on the roller's
position. Adjust the height by loosening the
bolts (A) on both sides of the mower. Detach
the bolt (B) on both sides of the mower. Raise
(or lower) the roller and reattach the bolts (B)
when the roller has the desired position.
Finally, tighten all the bolts.
Picture of an incorrectly adjusted roller and a
correctly adjusted roller.
The skids have several possible settings.
Remove the bolts (B), raise or lower the skids
and reattach the bolts (C). There are skids on
both sides of the mower.
Picture of correctly adjusted and incorrectly
adjusted skids.
Adjust the top bar so the front of the mower is
roughly 15 degrees higher than the rear of the
mower.
P. Lindberg A/S
Tlf: 70212626
B
10
Sdr. Ringvej 1
DK-6600 Vejen
A
C
MAN 9044853 EN V5
www.p-lindberg.dk
e-mail: salg@p-lindberg.dk