Stanley STR-4 IN 1 Bersetzung Der Originalbetriebsanleitung Seite 22

G
B
5.6 Brush cutter-grass trimmer-pruner-hedge cutter-combination device: Extension (only for high-button)
Module 6
20
a
26
Teil C
Teil B
A12
22
10
10
26a
10
a
Mounting
Remove the transport cover.
Connect the drive unit, the
extension and assembly:
Insert the ends of the modules
to be connected together into
one another.
Make sure that the locking pin
(26) is snapped in place. Check
what has been pulled apart
on a trial basis. Fold down
the cover (26a) and secure
the modules by tightening
the locking screw (10). Carry
out the process for each of
the drive unit and extension
separately.
Release the drive unit, the
extension and assembly:
Release the locking screw (10).
The cover (26a) jumps back.
Hold the locking pin (26) found
under the cover pressed and
26
simultaneously release the
modules from one another by
26a
carefully pulling them apart.
Carry out each process for
the drive unit and extension
separately.