Installation Instructions; Safety Instructions; Installation - Truma VB 10 Gebrauchsanweisung

Installation instructions

Safety instructions

This device contains parts that could cause sparks or
a light arc!
Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use
(e.g. EN 1648). The national legislation and regulations must
be observed.
In other countries always observe the respectively valid
regulations.
Only qualified technicians may assemble and connect electri-
cal devices!
Ensure that the power supply has been disconnected before

installation!

Only use the supplied parts and the specified cable cross-sec-
tions and fuses to connect the device!
Only use suitable and fully functional tools.
Only wire the device as specified in the supplied wiring diagram!
Installation
Remove the equipment pack (accessories) and check it is
complete:
1 instructions for installation and use
8 flat pin bushing
8 insulated covers
4 mounting screws
The device should be installed away from damp and wet. The
installation site should be clean, dry and well ventilated. Dur-
ing operation, the casing can heat up to around 70 °C.
The designated room in which the device is to be installed
may not undercut the following dimensions as a minimum
clearance of 100 mm all-round must be observed.
Length: 356 mm / Width: 319 mm / Height: 166 mm
The installation space for the device must have ventilation
openings at the top and side that provide a total opening
surface of 65 cm².
Liquid electrolyte batteries need to be placed in a separate
box with ventilation directed to the outside. The gel and AGM
batteries do not need a separate box. Observe the installation
regulations of the battery manufacturer.
Securely attach the device using the 4 supplied mounting
screws.
Ensure that the ventilation slits remain free! Inadequate
ventilation can cause the device to overheat!
15