Installing The Benches And Backrests; Installing The Windows And Doors; Fit The Skirting Boards; Ventilation Slit Installation - Sentiotec Scala Medium Montageanleitung

Instructions for installation p. 15/16

4.6. Installing the benches and backrests

4.7. Installing the windows and doors

First insert the window frame on the inside and screw it to the cabin wall. Insert
the glass from the outside and fit the second window frame.
Place the inner door from the lobby into the door opening and fix it by fitting the
door panel inside from the sauna interior.
Place the outer door in the door opening and fix it by fitting the door panel from
the inside.

4.8. Fit the skirting boards

4.9. Ventilation slit installation

EN

4.10. Installing the outer roof

Glue and screw the roof rafters and place them in the recesses according to
the illustration. Screw the roof rafters to the block planks. Attach the tongue and
groove planks to the roof rafters.
Attach support strips 82°- 40x40 to the back of the tongue and groove planks,
support strips 82°- 1719x128x40 to the front and support strips 82°- 1828x130x40
to the side.
Attach the side wind battens (82°- 150x20) and finally the wind battens
(1718x150x20) to the front and back.
The roofing felt included in the scope of delivery serves as an initial roofing.
We also recommend covering the roof with bitumen shingles, sheet metal or
a suitable foil.

4.11. Installing the terrace

Place the floor frame of the terrace as shown in the photos (see page 26) and
screw it to the base frame of the cabin. Then mount the cover boards (825x95x25)
to the base frame.
Fit the floor boards.

4.12. Installing the corner strips and ventilation grille

4.13. Installing the screen elements and roof supports