Completing The Cabin Exterior; Roof Installation; Installing Interior Fittings; Installing The Electrical Equipment - Sentiotec Family Medium Montageanleitung

Instructions for installation

6.3. Completing the cabin exterior

Install the "Covers, front" by screwing from the inside - flush with the inner side.
Pay attention to the element with cut-out for the control panel - this can be fitted
on the left or right.
Install the "Cover, top front" above the glass by screwing from the inside.
Mount the "Cover slats, outside" using screws.

6.4. Roof installation

Install the roof support slats. Start with the strip of LEDs on the rear wall.
Insert the roof elements and screw them to the cabin walls. Observe the cable
outlets.
Install the cover slat, inside.

6.5. Installing interior fittings

Mount the ventilation slide.
Install the bench support slats.
Place the upper and lower benches on the bench support slats provided for this
purpose.
Screw the bench foot to the upper angled bench and screw the other end of this
to the rear upper bench. Finally, screw the bench foot to the wall element.

6.6. Installing the electrical equipment

Observe the operating instructions for your sauna heater and sauna
control unit.
You need a hole measuring Ø 2 cm in the cable shaft for the heater supply cable.
Drill the cable outlet at a right angle and route the cable as far as the roof to the
power unit for the sauna control (5 x 2.5 mm
Repeat for the heater sensor - Ø 1 cm - 15 cm below the ceiling.
To cover the cables, use the cable cover slat. Shorten them with a saw as required.
Route the data cable for the control panel up to the cabin roof, to the power unit
for the sauna control.
).
2
p. 13/14
EN