Stihl SE 62 Gebrauchsanleitung Seite 28

English
Route the connecting cord
and extension cord properly:
Observe the minimum
–
cross-section of the
individual cords – see
"Connecting the machine
to the power supply"
Route and mark the
–
connecting cord so that it
cannot become damaged
and no one is endangered
– danger of stumbling!
Use of unsuitable
–
extension cords can be
dangerous. Use only
extension cords that are
approved for outdoor use
and are correspondingly
marked and have a
sufficient cross-section
The connector and
–
coupling of the extension
cord must be waterproof or
routed in such a way that
they cannot come into
contact with water – the
connector and coupling of
the extension cord must
not lie in water
don't let the cord rub
–
against edges or pointed
or sharp objects
26
don't squeeze the cord
–
under doors or windows
if cords become snarled –
–
unplug the power plug and
unsnarl the cord
always unroll the
–
connecting cord from the
cable reel completely to
avoid risk of fire due to
overheating
During operation
If the connecting
cord is damaged,
immediately dis-
connect the power
plug from the wall
outlet – risk of
electric shock!
Ensure that the connecting
cord is not damaged by being
driven over, squashed or
pulled, etc.
Never unplug the power plug
by pulling on the connecting
cord: always grip the plug
itself.
Only touch the power plug,
connecting cord and
extension cord and electrical
plug connections with dry
hands.
Never spray electrical devices
with water – Danger of short-
circuiting!
In the event of imminent
danger or in an emergency –
move switch to 0 .
Never let the machine run
unattended.
Do not leave the machine
outdoors in the rain.
The machine may only be
operated in an upright
position. Do not cover the
machine and ensure
adequate motor ventilation.
Ensure that the filter element
is always undamaged.
If foam develops or liquid
escapes, stop work
immediately, unplug the
power plug, and empty the
container.
If the machine is subjected to
unusually high loads for which
it was not designed (e. g.,
heavy impact or a fall), always
check that it is in good
condition before continuing
work - refer also to the chapter
"Before starting work". Also
make certain that the safety
mechanisms are working
properly. Never continue
SE 62, SE 62 E