Beurer BM 40 Gebrauchsanweisung Seite 23

4: The pump pressure is higher than 300 mmHg,
•
5: There is a system or unit error.
•
In the above cases, you must repeat the measurement. Make sure
that the cuff tube is properly inserted and that you do not move or
talk. Re-insert the batteries if necessary, or else replace them.
10. Specifications
Model no. BM 40
Measurement Oscillometric, non-invasive blood pressure
method measurement on the upper arm
Measurement Cuff pressure 0 – 300 mmHg,
range systolic 60 – 280 mmHg,
diastolic 30 – 200 mmHg,
Pulse 30 –180 beats/minute
Display accuracy Systolic ± 3 mmHg, diastolic ± 3 mmHg,
pulse ± 5 % of the value shown
Measurement Max. permissible standard deviation
inaccuracy according to clinical testing:
systolic 8 mmHg /diastolic 8 mmHg
Memory 2 x 60 memory spaces
Dimensions L 119 mm x W 109 mm x H 60 mm
Weight Approx. 257 g (without batteries)
Cuff size 22 to 35 cm
Permissible oper- + 5 °C to + 40 °C, < 85 % relative air humidity
ating conditions (non-condensing)
Permissible stor- - 10 °C to + 55 °C, <95 % relative air humidity,
age conditions 800 –1060 hPa ambient pressure
Power supply 4 x 1,5 V
Battery life For approx. 250 measurements, depending
on the blood pressure level and/or pump
pressure
Accessories Instruction for use, 4 x 1.5 V AA batteries,
storage pouch
Classification Internal supply, continuous operation, type
BF applied part, IP22, no AP or APG
Technical information is subject to change without notification
to allow for updates.
• This unit is in line with European Standard EN 60601-1-2 and
is subject to particular precautions with regard to electro-
magnetic compatibility (EMC). Please note that portable and
mobile HF communication systems may interfere with this
unit. More details can be requested from the stated Customer
Service address or found at the end of the instructions for use.
• This device is in line with the EU Medical Devices Directive
93/42/EEC, the „Medizinproduktegesetz" (German Medical
Devices Act) and the standards EN 1060-1 (non-invasive
sphygmomanometers, Part 1: General requirements),
EN 1060-3 (non-invasive sphygmomanometers, Part 3: Sup-
plementary requirements for electro-mechanical blood pres-
sure measuring systems) and IEC 80601-2-30 (Medical elec-
trical equipment – Part 2 – 30: Particular requirements for the
safety and essential performance of automated non-invasive
blood pressure monitors).
• The accuracy of this blood pressure monitor has been care-
fully checked and developed with regard to a long useful
23
AA batteries