Operation; Replaciing The Projection Pattern; Cleaning And Maintenance - EuroLite LAS-10 Bedienungsanleitung

6. OPERATION

With the POWER-switch, you can switch the device on and off.
Via the mode selector, you can choose the following modes:
1. Mode 1: Sound Activated.
2. Mode 2: Rotation.
3. Mode 3: Sound Activated with the laser full on.
In the AUTO-mode, the patterns are run automatically. You can adjust the speed with the SPEED-control.
In the MUSIC-mode, the laser runs sound-controlled.
Spatial effects of the projection patterns can be created by using a smoke-machine. Make sure that you do
not use too much smoke so that the laser beam is swallowed after a short distance and the audience cannot
see the projections.

6.1 Replaciing the projection pattern

Move the laser output cover downwards.
Carefully remove the projection pattern from the holder.
Insert the new projection pattern into the holder.
Close the laser output cover.

7. CLEANING AND MAINTENANCE

Laser products in discotheques are technical working installations and fall under the Equipment Safety Act.
This is why they must fulfill its requirements.
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Always disconnect from the mains when the device is not in use or before cleaning it.
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
Clean the front glass every two weeks from dust and smoke fluid residues.
DANGER OF LASER EXPOSITION!
Do not operate this device without plastic grating!
For changing the plastic grating, always switch off the device!
25/26 00038520.DOC, Version 1.1