Connection With The Mains; Inserting/Replacing The Batteries; Adjusting The Laser - EuroLite LAS-10 Bedienungsanleitung

suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.

5.3 Connection with the mains

Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
Showlasers must provide a manual safety shutdown enabling to interrupt the laser radiation at any time by
force. If the laser product is installed in the trussing system or in an unaccessible location, it must at least be
installed with a switchable power outlet.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!

5.4 Inserting/Replacing the batteries

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Caution!
Danger of explosion when batteries are replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

5.5 Adjusting the laser

Switch the device on via the power switch.
Loosen the fixation screws of the hanging-bracket and adjust the laser product to the desired projection area.
Call up all desired projection patterns in order to make sure that the projections only move in the
inaccessible showlaser area.
Make sure that no mirrorballs, shining surfaces etc. are located in the laser beam. Shining objects must be
removed from the laser area or be covered.
Tighten the fixation screws of the hanging-bracket so that the laser beam cannot easily be moved.
24/26 00038520.DOC, Version 1.1