Lorelli INFINITY Bedienungsanleitung Seite 12

1. Apply the stroller's brakes
2. Fold the canopy as much as possible.
3. Fold the backrest as far as possible to the front, to that it rests against the bumper bar.
4. Pull the mechanisms
5. A properly folded stroller should look as shown in Figure 21.
ATTENTION, for the correct preparation of the pram body for a newborn after removing it from the transport
box, perform the following actions:
1. Place the cot on a table
2. With one hand lift the metal frame on one side ofthe pram body. (Figure 22)
3. With the other hand press the bottom and hold the metal support.
4. Pressing the bottom, grasp the support strap and pull it towards the outside of the pram body until it reaches
the limiters. (Figure 23)
5. Repeat this procedure with the other support, until the cot is fully expanded; it must look as in Figure 24.
6. Replace the mattress and the fabric liner.
7. Lift up the carrying handle until you hear a click. (Figure 25)
8. To fold the carrying handle, press both buttons on the inside at the base of the handle with your thumbs at the
same time. (Figure 26)
9. Install the pram body adapters by sliding them from left to right on the designated places, as indicated in
figure 27.
10. Install the pram body on the stroller, ensuring that the adapters are positioned and locked in the intended
holes in the frame (Figure
simultaneously press the buttons on both sides of the pram body and pull up (Figure 29). The pram body should
only be installed facing the parents (Figure 28).
11. Finally, place the footmuff and fasten it with a zipper and buttons onto the pram body.
12. The pram body should be parent-facing
I. To clean the metal parts, clean with a wet cloth and wipe dry.
2. To clean the plastic parts, use a towel, water and a soft detergent.
3. To clean the textile parts, use a solution for cleaning of upholsteries.
4. When not in use, never place other objects in or on the stroller!
5. Always dry and air the stroller if it gets wet.
6. Run regular clean-ups over the wheel axes and the plastic elements.
7. Always clean the wheel axes and the plastic elements after using the stroller on sandy or dusty surfaces!
8. DO NOT LUBRICATE
9. Run regular checks for loose or damaged parts and if there are such parts, immediately replace them with new
ones!
FOLDING
located on both sides of the handle and push it down. (Figure 20)
PRAM
and remove the mattress
28). The click means that the basket
MAINTENANCE
the wheel axes or other movable parts of the stroller! Just clean them!
BODY
and fabric liner.
is locked in place.
AND CARE
In order to remove,