Preparations For Treatment; Assembling The Heating Lamp - schwa-medico PierenHeat TDP Gebrauchsanweisung

schwa-medico Operating Manual - PierenHeat TDP / PierenHeat TDP
2

Preparations for treatment

Assemble the heating lamp for first time use. The three parts to be assembled are
the treatment part, the heating head, the rod with the operating panel and the
presser foot.
First remove all packaging.
Secure with the screws and nuts, the moving parts of the presser foot and place it
on the floor.

Assembling the heating lamp

Insert the upper part with the operating panel into the base rod .
1
Fix the upper part at the right heigth with the setscrew thread . Turn the locking
screw to the right.
WARNING: Never extract the rod in excess of 20 cm.
Now insert the heating head , carefully turning and pressing, and connect the
plug on the head with the plug on the arm of the lamp.
The PierenHeat TDP Lamp is now ready to operate.
With the fixing elements , you
can fix the set inclination of the
rods.
As and when necessary carefully
tighten the screws (center screw
on the mineral plate or the screws
on the hinge). Take care not to
screw too tight to avoid damaging
the screw threads.
26