VEVOR W-2000B5 Bedienungsanleitung Seite 8

In normal use, the nozzle wings are horizontal as shown here. This provides a
vertical fan-shaped pattern which gives maximum, even material coverage as the
gun is moved back and forth parallel to the surface being finished.
Spraying
Set inlet pressure at no more than 43 PSI for the large spray
guns and 30 PSI for the small spray gun. For optimum
performance, some materials may spray better at lower PSI
ratings. If unsure, always test at PSI ratings before using on
final production. Try spray. If it is too fine, decrease the air
Spray pattern may be infinitely adjusted
from round to flat.
- 7 -