Accessories - Vevor W-2000B5 Bedienungsanleitung

Will not spray.
Fluid leakage from
packing nut.
Dripping from fluid
tip.
Thin, sandy
coarse finish.
Thick, dimpled
finish
resembling orange
peel.
A.) No air pressure
at gun.
B.) Fluid pressure
too low with internal
mix cap and
pressure tank.
C.) Fluid control
screw not open
enough.
D.) Fluid too heavy.
A.) Packing nut
loose.
B.) Packing worn or
dry.
A.) Dry packing.
B.) Sluggish needle.
C.) Tight packing nut.
D.) Worn fluid nozzle
or needle.
A.) Gun held too far
from surface.
B.) Atomization
pressure set too high.
Gun held too close to
surface.
Parts List and
A.) Check air supply and
airlines.
B.) Increase fluid pressure at
tank.
C.) Open fluid control screw.
D.) Thin material or change to
pressure feed.
A.) Tighten, but not so tight as
to grip needle.
B.) Replace packing or
lubricate.
A.) Lubricate.
B.) Lubricate.
C.) Adjust.
D.) For pressure feed, replace
with new fluid nozzle and needle.
A.) Move gun closer to surface.
B.) Adjust atomization pressure.
Move gun further from surface.

Accessories

- 12 -