VEVOR GB-GO12A-R Bedienungsanleitung Seite 14

this indicates a leak which must be corrected before use.
• Retest after fixing the fault
• Turn OFF the gas at the cylinder after testing.
• If leakage is detected and cannot be rectified.Do not attempt to cure
leakage but consult your gas dealer.
Lighting Instructions for barbecue
1.Turn the control knobs clockwise to "OFF" position.
2.Connect the regulator to the gas cylinder. Turn the gas supply "on" at
the regulator. Check for gas leakage between the bottle and the regulator
with soapy water.
3.Press the control knob and continue to press while turning
counterclockwise to the "high" position (a click will be heard). If not, repeat
the process.
4.If the burner is still not ignited after a new attempt, wait for 5 minutes
and repeat step 3.
5.Adjust the heat by turning the knob to the High/Low position.
6.If the burner does not light. Light the appliance with a match using the
lighting hole in the side of the appliance. Consult your gas dealer to rectify
the ignition.
7.To turn the barbecue "off", turn the gas cylinder valve or regulator switch
to the "off" position and then turn the control knob on the appliance
clockwise to the "off" position.
Warning:If the burner fails to ignite, turn the control knob off (clockwise)
and also turn the cylinder valve off. Wait five minutes before attempting to
relight with ignition sequence.
Before cooking for the first time, operate the barbecue for about 15
minutes with the lid closed and the gas turned on LOW.This will "heat
clean" the internal parts and disperse any odours from the painted
surfaces.
Clean your barbecue after each USE. DO NOT use abrasive or flammable
cleaners, as it will damage the parts of the product and may start a fire.
Clean in warm soapy water.
WARNING: Accessible parts may be very hot. Keep young children away
from the hot appliance at all times (even while cooling down!).
It is recommended that protective gloves (e.g. oven gloves) be used
when handling particularly hot components.
- 12 -