Non-Dell Rack Requirements; Before You Begin; Important Safety Information; Rack Stabilizer Feet - Dell PowerVault 220S Installationsanleitung

Non-Dell Rack Requirements

NOTICE: This rack kit is intended to be installed by trained service technicians in a rack that
meets the specifications of American National Standards Institute (ANSI)/Electronic Industries
Association (EIA) standard ANSI/EIA-310-D-92, International Electrotechnical Commission
(IEC) 297, and Deutsche Industrie Norm (DIN) 41494. One rack kit is required for each system
that is installed in a rack.

Before You Begin

Before you install your system in the rack, read the "Safety Instructions" in the front of this
document, as well as the safety instructions in your System Information booklet for
additional information.
CAUTION: When installing multiple systems in a rack, complete all of the
procedures for the current system before attempting to install the next system.

Important Safety Information

Observe the safety precautions in the following subsections when installing your system in
the rack.
CAUTION: You must strictly follow the procedures in this document to protect
yourself as well as others who may be involved. Your system may be very large
and heavy, and proper preparation and planning are important to prevent injury
to yourself and others. This becomes increasingly important when systems are
installed high up in the rack.

Rack Stabilizer Feet

CAUTION: Installing systems in a rack without the front and side stabilizer feet
installed and anchored to the floor could cause the rack to tip over, potentially
resulting in bodily injury or death under certain circumstances. Therefore,
always install and anchor the stabilizer feet before installing components in the
rack.
CAUTION: After installing systems in a rack, never pull more than one system
out of the rack at one time. The weight of more than one extended system could
cause the rack to tip over and cause injury.
The stabilizer feet help prevent the rack from tipping over when a system or other
component is pulled out of the rack. See the documentation provided with the rack cabinet
for instructions on installing and anchoring the stabilizer feet.
1-4 Ra c k I n st allat io n G u ide