Installing The Rack Front Panel - Dell PowerVault 220S Installationsanleitung

To remove the tower system front panel (see Figure 1-9):
6
Position the system so that the front panel extends about 2.5 centimeters (1 inch)
a
beyond the edge of the table or work surface.
Remove the 14 4-40 x 0.25-inch pan head black T-10 Torx screws that secure the
b
tower front panel to the chassis.
Remove the front panel from the system chassis, taking care to avoid damaging
c
the five plastic light pipes that extend through the front panel.

Installing the Rack Front Panel

Position the rack front panel on the front of the system chassis, using care to install the
1
five light pipes in their holes in the front panel.
NOTE: In the next step, start all 14 T-10 Torx screws in their holes before tightening any
of the screws to ensure proper alignment.
Secure the rack front panel to the chassis with the 14 T-10 Torx screws that you
2
removed in step 6 of the last procedure, "Removing the Bezel, Drives, Covers, and
Front Panel" (see Figure 1-9).
Reinstall the power and cooling modules (if they were removed).
3
NOTE: Do not install the hard drives until the next procedure, "Installing the System in
the Rack," is completed.
Ra c k In s ta l la ti on Gu i d e
1-13