Removing The Rack Doors; Removing The System From The Rack - Dell PowerVault 220S Handbuch

Removing the Rack Doors

You must remove the doors from the rack cabinet to provide access to the interior of the
rack and to prevent damage to the doors.
For Dell rack cabinets, see the documentation provided with the rack for instructions on
removing rack doors.

Removing the System From the Rack

CAUTION: If you are removing more than one system from the rack cabinet,
remove the highest of the systems first. Complete the removal of the first
system from the rack before starting the second. Never extend more than one
system from the rack at a time.
WARNING: Removing a system from a position high up in the rack cabinet
requires up to four people and might require a sturdy, elevated platform on
which to stand. A mechanical lifting platform or similar equipment of the proper
capacity might also be useful. If you attempt to remove and lower the system
without enough people to safely perform the task, you risk personal injury to
yourself and others and damage to the system.
Shut down and turn off the system.
1
See the Installation and Troubleshooting Guide for instructions.
Disconnect the cables and power cord from the back of the system.
2
Loosen the thumbscrews that secure the front panel to the front vertical rails (at the
3
front of the rack cabinet).
Using two or more persons, grasp the system at each front handle and slide the system
4
out of the rack mounting rails (see Figure 1-2).
Place the system on a smooth work surface.
5
Position the system so that the front panel extends 2.54 centimeters (1 inch) beyond
the edge of the table or work surface.
Ra c k -to -To we r C o nv e r si on Gu i d e
1-5