Installation And Assembly - Kessel SonicControl Anleitung Für Einbau, Bedienung Und Wartung

3.1 Wall mounting of the control unit
The control unit must be installed in a dry and
frost free area – preferable indoors where any
alarms and control unit message can be seen
/ heard. Do not install the control unit in direct
sunlight!
Caution!!!! The control unit is not to
be installed inside the oil or coale-
scence separator!!!
In order to mount the control unit the control
unit cover does not need to be opened. Pre-
drill 2 x 6mm diameter holes 168mm apart (use
the drilling template if required)
Installation:
1. Drill two holes
2. Insert two dowels
3. Screw in two screws to proper depth
4. Hang control unit on two screws
5. Affix the control unit on the screws by pus-
hing the control unit down until it seat firmly
on both screws.

3. Installation and Assembly

Illustration of SonicControl control unit
38