Configuration Parameters - Dea Net-Exp Bedienungsanleitung Und Hinweise

NET-EXP
8 DETAILED PARAMETER LIST

Configuration Parameters

P078 Enabling the NET-EXP expansion board
Warning: The expansion board is disabled by default.
Warning: If a default of settings is carried out, the parameters must be correctly set.
P079 INPUT_1 input type selection
P080 INPUT_2 input type selection
P081 INPUT_3 input type selection
P082 INPUT_4 input type selection
P083 INPUT_5 input type selection
P084 INPUT_6 input type selection
• 000: free contact
• 001: constant resistance 8K2
P085 INPUT_1
P086 INPUT_2
P087 INPUT_3
P088 INPUT_4
P089 INPUT_5
P090 INPUT_6
• 000: NONE
• 001: START
• 002: PED
• 003: OPEN
• 004: CLOSE
• 005: OPEN_PM
• 006: CLOSE_PM
• 007: ELOCK_IN
P091 OUTPUT_1
P092 OUTPUT_2
P093 OUTPUT_3
P094 OUTPUT_4
P095 OUTPUT_5
P096 OUTPUT_6
P097 OUTPUT_7
P098 OUTPUT_8
• 000: NONE
• 001: WARN_FIX / SAS_OUTPUT
• 002: WARN_INT
• 003: FLASH_FIX
• 004: FLASH_INT
• 005: ELOCK_M1
P099 AUX_OUT_TEMP output operation (if activated):
Se=0 disabled;
If>0 output controlled by the AUX_IN input in timed mode (the value set indicates the
off delay time in seconds).
22
• 008: PHOTO_1
• 009: PHOTO_2
• 010: SAFETY_1
• 011: STOP
• 012: FCA_1
• 013: FCA_2
• 014: FCC_1
• 015: FCC_2
• 006: ELOCK_M2
• 007: ELOCK_INV_M1
• 008: ELOCK_INV_M2
• 009: EBRAKE_M1
• 010: EBRAKE_M2
• 011: MINUTERIE
Default
NET24N - NET230N
000
• 000: Disabled
• 001: Enabled
000
000
000
000
000
000
017
018
016
011
000
000
• 016: SAFETY_2
• 017: OPEN_INT
• 018: OPEN_EXT
• 019: AUX_IN
• 020: SAFETY_INHIBITION
• 021: RESET
009
010
001
012
011
013
014
001
• 012: ALARM
• 013: TRAFFIC_LIGHT_INT
• 014: TRAFFIC_LIGHT_EXT
• 015: AUX_OUT_INPULS
• 016: AUX_OUT_STEP
• 017: AUX_OUT_TEMP
000
• 000: "Disabled
• >000: "Timed output
(1sec..................255sec)