Cleaning And Maintenance - Silvercrest SPB 97 A1 Bedienungsanleitung

CAUTION – PROPERTY DAMAGE
► Ensure that no paraffin wax
clothes during use. This can be very difficult
to remove and may result in discolouration.
1) Remove any jewellery, such as rings or bracelets.
2) Treat your hands with a rich cream, such as
hand cream.
3) Briefly immerse your hand in the paraffin wax
for about 1 - 2 seconds. Remove your hand
again and wait for the paraffin wax
harden.
4) Repeat this process about 6 - 7 times so that
a layer of paraffin wax
NOTE
► If you have the feeling that the temperature
is too high or too low at any time, correct this
using the temperature control
► If you want to pause the heating of the ap-
pliance for a short time, turn the temperature
control to the left as far as the stop. The
HEAT control lamp
adequate substitute for removing the power
plug after finishing the treatment!
5) Insert your hand into one of the plastic bags
and twist the bag
that no air can escape.
WARNING – RISK OF INJURY!
If you pull the plastic bag
not walk around with it on. Risk of slipping.
6) After about 15–20 minutes, remove the plastic
bag together with the paraffin wax
dispose of both in your household waste.
For hygiene reasons, paraffin wax
already been applied to the body must not be
reused!
│
■ 14 GB
gets onto your
to
forms.
.
goes out. This is not an
closed at the opening so
over your foot, do
and
that has
NOTE
► Always remove the grille
paraffin wax
the application.
NOTE
► Pure paraffin wax cannot spoil. After every
use of the paraffin bath, impurities can get
into the paraffin wax
mend replacing the paraffin wax
already been melted in the appliance after
no more than one year.

Cleaning and maintenance

NOTE
► If the paraffin bath is only being used by one
person, replace the paraffin wax
as you notice dirt or suspended particles in
the paraffin wax
also be cleaned when doing this.
► If the paraffin bath is being used by several
people, the paraffin wax
changed before every treatment for hygiene
reasons.
,
► To reorder paraffin wax
contact our Customer Service (see section
"Warranty and service"). Have the IAN
number of the item concerned to hand. You
will find this on the cover of the operating
instructions and below the service address.
To remove the paraffin wax
–
Remove the power plug from the mains
power socket.
–
Leave the paraffin wax
–
Replace the plug in the mains power socket.
–
Put the lid
–
Set the temperature control
wait for approximately 10 minutes (depending
on the room temperature).
–
Remove the power plug from the mains
power socket.
from the liquid
immediately after completing
. We therefore recom-
that has
as soon
. The appliance should
should be
or plastic bags
proceed as follows:
to harden overnight.
on.
to "hot" and
SPB 97 A1
,