Troubleshooting - Saeco PicoBaristo HD8927 Bedienungsanleitung

English
34
Error code
Other error codes
Problem
The machine does not
switch on.
The machine is in DEMO
mode.
The drip tray is quickly
filled.
The coffee grounds
container full icon remains
displayed.
Problem
If the above solutions do not help to remove the error code icon from the
display and bring the machine back to normal working order, contact the Philips
Saeco hotline. Contact details can be found in the warranty booklet or on
www.saeco.com/support.

Troubleshooting

Cause
The machine is disconnected or the
main switch is in the OFF position.
The standby button has been pressed
for more than 8 seconds.
This is normal. The machine uses
water to rinse the internal circuit and
brew group. Some water flows
through the internal system directly
into the drip tray.
The coffee grounds container was
emptied while the machine was
switched off.
The coffee grounds container was
placed back too fast.
Cause
Solution
Check if the mains cord is inserted
correctly.
Make sure that the main switch is set
in ON position.
Switch the machine off and then on
again using the main switch on the
back of the machine.
Empty the drip tray when the 'drip
tray full' full indicator pops up
through the drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
Always empty the coffee grounds
container while the machine is ON.
If the coffee grounds container is
emptied while the machine is
switched off, the coffee cycle
counter is not reset. In that case, the
'empty coffee grounds container'
message will stay on the display even
though the container is not full.
Do not place back the coffee
grounds container until the screen
message prompts you to put it back.
Possible solution
Remove the water tank
from the machine. Check
the water tank
compartment to check if
there are any coffee
beans on the bottom.
Remove them. Switch
the machine on and off.
Switch the machine off
and switch it back on
again after 30 seconds.
Try this 2 or 3 times.