Measuring The Water Hardness - Saeco PicoBaristo HD8927 Bedienungsanleitung

English
16
AQUACLEAN
FILTER
2 / 8
DESCALE BEFORE
ACTIVATING FILTER
1 2
3
4
numbers of red squares
1
- The display shows the number of AquaClean filters that have been
installed previously from 0 to 8 filters.
2 The display asks if you want to activate a new filter. Press the OK button to
confirm.
3 Follow the instructions on the screen to install the new filter, to fill the water
tank, to insert the hot water dispensing spout. Press the OK button to
confirm each step.
- The filter activation screen appears with a progress bar showing the
progress of the filter activation.
- When activation is finished, the display shows a tick to confirm activation.
- Then the machine ready screen appears with the AquaClean 100% icon
to indicate that the filter has been activated.
Replacing the filter after 8 filters were used
1 When the filter icon starts flashing on the display, press the MENU/SPECIAL
DRINKS button, select MENU and press the OK button to confirm. Scroll to
select the AquaClean filter. Press the OK button to enter the filter menu.
- The display tells you that you need to descale the machine before
activating the new filter.
2 Press the OK button to start the descaling procedure.
- Press the ESC button several times to leave the filter menu if you do not
want to descale right away.
3 At the end of the descaling procedure, the display asks you if you want to
install the AquaClean filter.
- Follow the steps in 'Replacing the AquaClean filter'.

Measuring the water hardness

To be able to adjust the machine settings to the water in your region, please
measure the water hardness with the water hardness strip supplied.
1 Immerse the water hardness test strip (supplied with the machine) in tap
water for 1 second.
2 Remove the water hardness strip and and wait for 1 minute.
3 Check how many squares have changed into the red colour and check the
water hardness in below table.
value to be set
1
water hardness
very soft water