Technical Description; Control Elements - Waeco PerfectCharge DC20 Montage- Und Betriebsanleitung

PerfectCharge/PerfectPower
5

Technical description

The light weight and compact construction allows the converters to be easily
installed in mobile homes, commercial vehicles or motor and sailing vessels.
The transformers convert a 12 Vg or 24 Vg supply from a car or boat battery
to a stable 12 Vg or 24 Vg voltage for connecting to equipment.
The isolation of the input and output voltages means the output voltage can
be kept stable without interference from the input circuit.
Because the maximum output current is electronically regulated, the charge
converters can be used to charge batteries to generate electricity in cars or
on boats.
The devices are equipped with protection against shorting and overloading.
If the protective function triggers, the device switches off and then switches
on again when correctly connected.
5.1

Control elements

No. in fig. 1,
page 3
1
2
3
4
5
6
7
8
9
EN
Explanation
Output terminals
Connection for switching on with on-board voltage (e.g. igni-
tion or external switch)
"Power On" LED: There is voltage at the output terminals on
the converter. The converter is ready for use.
"Battery Low" LED: The input battery is no longer sufficiently
charged.
"Overload" LED:
– If a consumer is connected: The converter is shorted or
overloaded.
– If connected as a charger: The converter is in the full cur-
rent charging phase.
Air outlet
Main switch
Positive cable (red) to input battery
Negative cable (black) to input battery
Technical description
29