Sharp RT-116H Bedienungsanleitung Seite 8

RECORDING
When recording important
to ensure that the desired
V Operate the unit in numerical order.
DIGITAL TAPE COUNTER
Push the button at the side of the counter
counter will advance while recording
readi ngs provide a useful
RECORD LEVEL FINE CONTROL
RECORD LEVEL
83 x
38 - a
PEAK/d3 L
When recording from
SA-116H/E, this control
recording level has been properly
level -is not suitable, or when
external unit connected to the AUX sockets of SA-116H/E,
when recording from microphones,
suitable, adjust the recording
control, so that the peak level display meter (LEDs) reaches
the "0" mark on the scale at the highest levels to be recorded.
This record level adjustment
channels simu Itaneously.
selections. be sure to make a prel iminary test
material is being propeily
to reset to "000".
or playback
reference during recording
RECORD
10
Lower Raise
recording level. recording
turntable RP-116H/E and
is usually set at ' 'O" because the
adjusted. However. when this
recording iS to be done from an
and the levels
level with the RECORD
operates on the right
recorded.
(Rear panel)
RIG* CEFT
The
is in progress. These
and playback.
fevel. RECORD LEVEL
When recording
SA-116H/E,
However, when
receiver
and left channels
from unit connected
unbalanced
recording level balance.
or
BALANCE
are not
level fine
CEFT
and left
6
RECORDING FROM
Switch on both the
the RT-116H/E.
Set the function selector
for the programme you
increase the volume level slightly.
Place the cassette to
cassette compartment.
recorded cassette, refer
erasure protection.
set the TAPE SELECTOR
position for the type of tape being used.
To suppress tape hiss,
switch to the ON position.
needed, set the DO LB Y NR switch to the OFF
position.
Recordings made with
circuit on must be played
on for best results.
Push the PAUSE button.
Push the REC button.
PLAY button.
Set the RECORD level fine control to "O"
position, and set the record
control (located on the rear panel of the unit)
to the centre position.
instructions below.
Push the PAUSE button
it and begin recording.
The volume and tone controls
E may be adjusted with no effect on the record-
ing level input signal .
Push the PAUSE button
recording. The tape will stop at this point. To
resume recording from
the PAUSE button by pushing it a second time.
BÄLANCE CONTROL
from turntable RP-116H/E
this control is set in the centre
recording from a source
which are not balanced,
to the AUX sockets
programme sources, this control
When this control
LEFT, the left channel is boosted (and the
right channel drops); when turned
the RIGHT, the
(and the left channel drops).
THE RECEIVER
receiver SA-116H/E and
on the SA-116H/E
wish to record, and
be recorded into the
When using a pre-
to page 3 regarding
switches to the
set the DOLBY NR
If this circuit is not
the DOLBY NR
with this circuit
This will also engage the
level BALANCE
For details refer to
a second time to release
on the SA-116H/
to temporarily stop
the same point, release
or receiver
position.
with input levels to right
or when recording
of SA-116H/E with
is used to adjust
is turned toward the
toward
right channel is boosted