Endress+Hauser iTEMP TMT 122 Bedienungsanleitung Seite 32

3 Commissioning
32
Min primary value Display the minimum process value. The process value is accepted at the
• V9H3 beginning of the measurement.
Hint!
Min. process value will be changed to the actual process value on write.
On reset to factory default, the default value is entered.
+10000
Max primary value Display the maximum process value. The process value is accepted at the
• V9H4 beginning of the measurement.
Hint!
Max. process value will be changed to the actual process value on write.
On reset to factory default, the default value is entered.
-10000
Default values Entry: 182 (Reset to factory default settings)
• V9H5
0
Output current Display of the actual output current signal.
• V9H6
Simulation Entry of simulation mode.
• V9H7 Entry:
Off
Entry of simulation value (current).
Current out (sim)
• V9H8 Entry: 3.58...21.7 mA
Security locking Release code for setting up.
• V9H9 Entry:
281
Function group: USER INFORMATION
Entry and display of measurement point description (TAG).
Tag number
• VAH0 Entry: 8 characters
-
Descriptor Entry and display of plant description.
• VAH1 Entry: 16 characters
-
Hardware Version Display of unit version,
• VAH2 e.g.: 1.0000 indicates version 1.00.00.
Software Version Display of software version,
• VAH3 e.g.: 8010 indicates version 1.0.
• Software Rev.
Serial number 8-digit display of E+H device serial numbers (see legend plates on the
• VAH4 device).
1. Hint only for Commuwin II operating matrix
2. not for thermocouples (TC)
iTEMP® HART® Communication
Off
On
Lock = 0
Release = 281
Endress+Hauser