Reducing The Feed (Reducing The Peel Width); Changing The Peeler Blade - Rothenberger Roscraper 800 Bedienungsanleitung

3.5.2

Reducing the feed (reducing the peel width)

To reduce the feed and the peel width, the feed wagon must be pivoted slightly more towards
the already peeled area.
Note: The bigger the pipe dimension of the pipe to be peeled, the less feed is necessary to
maintain a peel width of about 1/2 to 2/3 of the blade width.
Turn the adjustment screws only by 1/4 turn increments and afterwards peel for 2 or 3 rotations
so that the altered feed setting can take effect.
Screw out the left adjustment screw:
 Turn the left adjustment screw (1) for 1/4 turn (counterclockwise).
Screw in the right adjustment screw:
 Turn the right adjustment screw (2) for 1/4 turn (clockwise).
Check the feed:
 After the adjustment make sure that the feed wagon is fixed again so that it does not move.
Check the altered feed setting by peeling further.
3.6

Changing the peeler blade

Attention! The blade is very sharp! Handling the spare blades involves a high risk of
injury. Always wear cut-proof gloves as soon as you handle the peeling blades!
Loosen the screw:
 Loosen the hexagon socket head screw (2.5 mm) that secures the peeler blade on the blade
holder with the enclosed key and remove the old peeler blade.
Install new peeler blade:
 Make sure that the peeler blade lies flat on the blade holder and that it touches the stop with
its backside.
18 ENGLISH