Rothenberger ROSCRAPER 800 Bedienungsanleitung Seite 17

Application 1: Peeling pipe ends
Fully open the strap ratchet:
 Fully open the strap ratchet to unlock the slotted spindle. The black rod prevents the strap
from slipping out of the ratchet.
Put the Chain Peeler around the pipe:
 Put the assembled Chain Peeler around the pipe. If that is not possible, connect the ends of
the Chain Peeler after having put it around the pipe.
Align the peeling blade:
 Put the assembled Chain Peeler around the pipe. The blade must rest with about ½ - ¾ of
its width on the pipe end.
Tensioning the chain:
 Pull the strap using the black rod, so that the chain is tightens around the pipe. Make sure
that the chain is perpendicular to the pipe.
 Pull the black rod tight with one hand and hold/support it, using the black knob as support.
Use the ratchet to tighten the Chain Peeler around the pipe.
Application 2: Peeling the pipe for a saddle
Fully open the strap ratchet:
 Fully open the strap ratchet to unlock the slotted spindle. The black rod prevents the strap
from slipping out of the ratchet.
Put the Chain Peeler around the pipe:
 Put the assembled Chain Peeler around the pipe. If that is not possible, connect the ends of
the Chain Peeler after having put it around the pipe.
Align the peeling blade:
 Put the Chain Peeler at the appropriate point around the pipe and close the chain. The blade
should be set on the middle of the outer limit of the marking on the area of contact.
Tensioning the chain:
 Pull the strap using the black rod, so that the chain is tightens around the pipe. Make sure
that the chain is perpendicular to the pipe.
 Pull the black rod tight with one hand and hold/support it, using the black knob as support.
Use the ratchet to tighten the Chain Peeler around the pipe.
Note the indicators
Indicator on the spring wagon:
An indicator pin is located on the spring wagon. The Chain Peeler is tightened sufficiently when
the indicator pin is still visible.
ENGLISH 15