Mounting The Blade - Rothenberger 5.0305 Bedienungsanleitung

EXTENSION CORD SELECTION
Total Extension Cord
Length (feet)
25
50
100
150
200
RECIPROCATING SAW
* Storage case
* Blade
* hex wrench
FOREWORD
This Reciprocating Saw is designed for cutting
metal up to 20mm (3/4") thick, wood up to
300mm (12") thick (depending on the blade), and
various other materials, such as plastics, fiberglass,
hard rubber, etc.
SELECTING THE BLADE
For best performance, longer blade life, and
smoother cut, select the proper blade for the job.
When cutting metal always select a blade which
will allow at least three teeth to be engaged in the
thickness of material.

MOUNTING THE BLADE

This machine is supplied with a standard hex key
blade clamp.
DISCONNECT TOOL FROM POWER SOURCE.
1. Use hex wrench (supplied) to loosen blade
clamp screw. It may not be necessary to fully
remove the screw, just loosen enough for the
clamp to be opened enough to accept the
blade. Turn it counterclockwise about three to
four turns.
2. Insert the blade into the blade clamp until it
bottoms. When the blade is properly
positioned: the hole in the blade shank will
align with the hole inside the blade clamp.
Ensure that the locating pin is properly
positioned before tightening the screw.
3. Firmly tighten clamp screw.
4. To remove blade, loosen blade clamp screw
enough for the clamp to fully release the blade
15
Cord Size (AWG)
16
12
10
8
6
ENGLISH
WARNING: NEVER TOUCH BLADE
IMMEDIATELY AFTER USE, AS IT MAY BE HOT
ENOUGH TO CAUSE SEVERE BURNS.
TO PREVENT ACCIDENTAL ELECTRICAL SHOCK
THE SAW MUST BE HELD WITH ONE HAND ON
THE MAIN HANDLE AND THE OTHER HAND
ON THE RUBBER GEARCASE COVER. THE
RUBBER GEARCASE COVER MUST BE FREE OF
DAMAGE AND PROPERLY INSTALLED AT ALL
TIMES.
TO START AND STOP SAW
1. Make sure power circuit voltage is the same as
shown on the specification plate on the saw.
Connect saw to power circuit.
2. Hold saw firmly. Squeeze trigger switch to start
motor.
3. Release trigger to stop motor.
D-Handle Models only:
D-handle models also have a Lock Button. To lock
the switch in the on position, press the lock button
while the
switch is fully on. To release the lock, press the
switch and release it.