Removing The Chain Peeler; Adjusting The Feed; Increase The Feed (Widen Peel Width) - Rothenberger Roscraper 800 Bedienungsanleitung

- The peeling blades are subject to wear!
- Use only on cleaned pipe surfaces!
- Keep the Chain Peeler clean and dry in the suitcase!
- The thickness of the peel must be regularly checked with a suitable measuring device!
3.4

Removing the Chain Peeler

Releasing the tension:
 To remove the Chain Peeler from the pipe the ratchet of the ratchet strap must be opened.
 Do not use any extra tools to release the tension. Use the locking pawl on the strap ratchet
to controllably release the tension.
Removing the Chain Peeler:
 Disconnect the Chain Peeler or take it off in one piece.
Safely store the Chain Peeler:
 Disassemble the Chain Peeler after using it and put its parts back into the transport contain-
er. This will keep the tool in a good condition.
Note: After removing the Chain Peeler from the pipe, always make sure that you have complete-
ly scraped the marked area.
Additional notes:
In case of an insufficient peeling result, the blade has to be replaced.
In consideration of the processing guidelines of the fitting manufacturer and the tolerances spec-
ified therein (max. gap between pipe and fitting) the pipe may be peeled a second time.
The peeler blades are subject to wear
Use only on cleaned pipe surfaces.
When not in use, always keep the Chain Peeler clean and dry in the suitcase!
The thickness of the peeling must be checked with a suitable measuring instrument on a regular
basis.
3.5

Adjusting the feed

3.5.1

Increase the feed (widen peel width)

To increase the feed and the peel width, the feed wagon must be pivoted slightly more towards
the non-peeled area.
Note: The smaller the pipe dimension of the pipe to be peeled, the more feed is necessary to
maintain a peel width of about 1/2 to 2/3 of the blade width.
Turn the adjustment screws only by 1/4 turn increments and afterwards peel for 2 or 3 rotations
so that the altered feed setting can take effect.
Screw out the right adjustment screw:
 Turn the right adjustment screw (1) for 1/4 turn (counterclockwise).
Screw in the left adjustment screw:
 Turn the left adjustment screw (2) for 1/4 turn (clockwise).
Check the feed:
 After the adjustment make sure that the feed wagon is fixed again so that it does not move.
Check the altered feed setting by peeling further.
ENGLISH 17