Pre-Assembly Of Tabletop - Cor Level System Bedienungsanleitung

GB
9
8
Insert the last leg 2 into the cross beam 1 and attach it using the screws and nuts supplied.
Tighten the screws securely. The underframe is now fully pre-assembled.

4.3 Pre-assembly of tabletop

Ensure that a sufficiently large, dry and clean mounting surface is available for mounting the
tabletop. Be sure to cover this surface with blankets. Then carefully place the three parts of the
4
tabletop on the prepared assembly area with the underside facing upwards.
5
Insert and evenly distribute 3 slats per table joint into the groove provided.
2 8