VEVOR FLO500-RD Anweisungen Seite 8

(instructions intended for professionals only)
Disconnect the power supply before attempting any work on the device.
This device does not require any specific maintenance. In case service is
required, any work on the device must be carried out by a technician.
OPERATION
After reading these instructions,consider the following points before starting
the pump:
1.Verify that the pump rests on the floor of the basin,if it is not suspended
by the handle.
2.Verify that the discharge pipe is properly connected.
3.Verify that the electrical connection is 11 0 - 120 VAC 60 Hz.
4.Verify that the electrical socket is GFCI protected and in good
condition.Test GFCI protected outlet before use.
5.Verify that water and moisture cannot get near the power supply socket.
6.Verify that the pump is installed so as to prevent running dry.
NOTE: The Pump will not start without 4 "of water.
NOTE: The Pump will remove water down to 4 /5". The Pump stop
once 4/5" water level is reached.
NOTICE
Every time the pump is powered on, the motor will
automatically start for 2seconds as a self-test.
When the switch is turned off, the motor will be delayed for 2
seconds to stop working.
WARNING
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Unplug the Pump from its electrical outlet before performing any
inspection,main- tenance,or cleaning procedures.
If the pump is moved during operation,flush it out with clean water after
every use.
- 7 -