VEVOR FLO500-RD Anweisungen Seite 6

easy access for repair and maintenance and in accordance with local
plumbing code.
Connection to side inlets
As shown in the picture above, the pump has two side inlets (one on each
side) that are meant to connect additional fixtures. To connect to the side
inlets, one rubber coupling (1-1/2"x2") is provided along with the
clamps. Use this rubber coupling to connect the side inlet to the PVC pipe
coming from the fixture. An additional rubber coupling (with clamps) will be
needed if you want to use the other side inlet. If either side inlet is not being
used, ensure that you cap off the inlet not being used by screwing the end
cap into the case untill it is completely sealed.
Connection to inlets (top)
To connect to the top inlets, one rubber coupling (1-1/2"x2") is provided
along with the clamps. Use the rubber coupling to connect the top inlet to
the PVC pipe which should be from your vent connection. An additional
- 5 -