JUNO JB136D8 Benutzerinformation Seite 12

12
Setting and changing the time
After the first connection to the mains, wait
until the display shows
flashes.
1. Touch or
2. Touch or
3. Touch or
4. Touch or
The display shows the new time.
To change the time of day touch
and again until
Setting the DURATION
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the minutes for
DURATION time.
4. Touch or the DURATION time
starts automatically after 5 seconds.
5. Use or to set the hours for
DURATION time.
6. Touch . The DURATION time starts
automatically after 5 seconds.
When the set time ends, an acoustic
signal sounds for 2 minutes.
setting flash in the display. The appliance
deactivates.
7. Touch a sensor field or open the oven
door to stop the acoustic signal.
8. Turn off the appliance.
Setting the END
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for 2 minutes.
time setting flash in the display. The
appliance deactivates automatically.
and 12:00. "12"
to set the hours.
.
to set the minutes.
.
again
starts to flash.
and time
and the
4. Touch a sensor field or open the oven
door to stop the acoustic signal.
5. Turn off the appliance.
Setting the TIME DELAY
function
1. Set an oven function and temperature.
2. Touch again and again until
starts to flash.
3. Use or to set the minutes for
DURATION.
4. Touch .
5. Use or to set the hours for
DURATION.
6. Touch , the appliance switches to
the setting of the END function.
The display shows flashing
7. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
Appliance turns on automatically later on,
works for the set DURATION time and
stops at the set END time. At the set time
an acoustic signal sounds for 2 minutes.
and the time setting flash in the
display. The appliance deactivates
automatically.
8. Touch a sensor field or open the oven
door to stop the acoustic signal.
9. Turn off the appliance.
When the Time delay function
is activated, the display shows
a static symbol of the oven
function,
The dot shows which clock
function is on in the Clock /
residual heat display.
Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a programme)
and temperature.
2. Set the DURATION.
.
with a dot and .