VEVOR HJ-RB514A Bedienungsanleitung Seite 7

Installation step 3:
1. Install and fix the panels in the slots of the front and rear rods respectively, and
install the panels in the slots of the front and rear rods at an angle.
2. Place the 4 panels respectively in the front and rear of the rod slot and move to
the corresponding screw hole position and use screws M5X12 (⑧) and M5X12
spacer (⑨) locking fixed.
3. Finally, tighten all the screws to fix. (As shown in the picture)
Installation Step 4:
1. Install the aluminum roof rack basket onto the roof cross bar using the U-clamp
method: Place the U-shaped M8 screw (⑫) into the long holes on both sides of the
bracket clamp and secure it with the U-shaped screw, knob, and M8 nut (⑭+⑮).
Tips: Install the U-clip according to the length of the cross bar, and the position can
be installed on the inner/outer side of each base plate. (As shown in the picture)
Product usage limitations:
- 6 -