VEVOR HJ-RB514A Bedienungsanleitung Seite 6

Installation step 1:
1. Install the front and rear rods and the left and right curved rods together with the
left and right plastic connecting seats respectively, and lock them in place with
M6X16 hexagonal screws (⑥) and M6X16 spacers (⑦).
Note: Do not tighten the screws too much! (As shown in the picture)
Installation step 2:
1. Installation of U-clamp: use M6X10 screws (⑯), M6x16 spacers (⑰) and M6
square nuts (⑱) and U-clamp combination to install together, and then U-clamp
screws (⑫) and knobs + M8 nut (⑭ + ⑮) combination fixed in the holes of
U-clamp clipboard, and finally install the M6 square nuts into the left and right
panels of both sides slots on both sides and lock the screws tightly.
(As shown in the picture)
- 5 -