Attaching/Removing An Insertion Tool; Checking The Charging Level Of The Battery Pack; Charging The Battery Pack - Parkside Performance Passp 20-Li C4 Bedienungsanleitung Und Originalbetriebsanleitung

˜ Attaching/removing an
insertion tool
NOTE
The directional information in this
u
section should be interpreted as
meaning that the user is positioned
behind the product .
Tool holder:
u
drive .
Insertion tool: Socket/Socket
u
adapter ( ⁄ " (12.7 mm) to
1
2
⁄ " (19 mm)).
3
4
Attaching an insertion tool
(Fig. D)
Push the desired socket
o
tool holder .
1 ] [
For use with the socket adapter
o
Push the socket adapter
–
tool holder
1 ] [
Push a ⁄ " (19 mm) insertion tool
3
–
4
onto the socket adapter
For use with a bit holder and screw bit
o
(both not included in delivery):
Push the bit holder onto the tool
–
holder .
1 ] [
Insert a screw bit into the bit holder .
–
Removing an insertion tool
(Fig. D)
CAUTION! Risk of burns!
m
Insertion tools can become very hot .
u
Wear protective gloves whenever
appropriate .
Pull the insertion tool off the tool
o
holder .
[ 1 ]
˜ Checking the charging level
of the battery pack
Press next to the charging level
[ 8 ]
o
indicator on the battery pack
[ 9 ]
16 GB
⁄ " (12.7 mm) square
1
2
onto the
16 ] [
:
[ 15 ]
onto the
[ 15 ]
.
.
[ 15 ]
.
7 ] [
The charging level of the battery
o
pack is indicated by illumination of
7 ] [
the corresponding LED lights on the
charging level indicator
Indicator Colour
Red,
orange,
green
Red,
orange
Red
Charge the battery pack
o
only the red LED on the charging level
indicator is illuminated .
[ 9 ]
˜ Charging the battery pack
NOTICE! Risk of damage to the
m
battery pack
7 ] [
Do not expose the battery pack
u
to direct sunlight for long periods
and do not place it on a radiator .
Observe an ambient temperature of
max. +50 °C.
NOTE
You can find detailed instructions in
u
the user manual of the charger
If the battery pack
u
allow it to cool down before
charging .
1 . Remove the battery pack
product .
2 . Push the battery pack
charging slot of the charger
3 . Connect the charger
outlet .
4 . After charging: Disconnect the
charger from the socket-outlet .
[ 17 ]
.
9 ] [
Meaning
Fully
charged
Partially
charged
Needs to
be charged
when
7 ] [
!
[ 7 ]
.
17 ] [
is still warm,
[ 7 ]
from the
7 ] [
into the
7 ] [
.
17 ] [
to a socket-
[ 17 ]