Eibenstock EHB 32 / 2.2 R R/L Originalbetriebsanleitung Seite 17

S w i t c h i n g o n a n d o f f
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and release it again
Attention!
Only press the lock-on button when using a stand. In
case of every stop of the machine, the lock-on button has
to be released immediately by pressing the on/off switch.
Consequently, you can avoid an unintentional restart of
the machine (physical hazard).
The machine is equipped with two selecting wheels, which allow an adjust-
ment of load speed and torque.
These are in the intermediate block between handle and motor housing.
The speed adjustment (SPEED) is on the same side like the arrestor button.
Torque adjustment (POWER) is on the opposite.
Additional the machine has a change-over switch for reverse action.
It is on the top side between the selecting wheels.
Use the change-over switch only when the spindle is stopped.
M o d e o f A c t i o n o f S p e e d A d j u s t m e n t
Position "I" means minimum, position "IIIIIII" maximum speed.
Please pay attention that a permanent use with reduced speed can cause an
overload because the motor then gets less cooling air and therefore the ma-
chine will be overheated much faster.
So always use preferably the mechanical speed selection for changing the
speed.
17