Eibenstock EHB 32 / 2.2 R R/L Originalbetriebsanleitung Seite 16

The tool may be used only in two-hand operation or with the drill rig.

Keep the handles dry, clean and free of oil and grease.

Persons under 16 years of age are not allowed to use the machine.

Dress properly. Do not wear loose clothing or jewellery. Keep your hair,

clothing and gloves away from moving parts. Loose clothes, jewellery or
long hair can be caught in moving parts.
During use, the user must wear goggles, ear protectors and protective

boots.
Remove drill cuttings only with a hook or a brush.

During use, hold the machine with both hands and maintain a safe

standing position. Always consider the reaction moment of the
tool.
Always work with concentration. Always work in a carefully consid-

ered way and do not use the tool if you are lacking consideration.
For further safety instructions, please refer to the enclosure.
E l e c t r i c a l c o n n e c t i o n
Before starting the machine, please check the correspond-
ence between voltage and frequency against the data men-
tioned on the identification plate. Voltage differences of + 6 %
and – 10 % are allowed. The Hand-Held Drilling Machine is
made in protection class II. Only use extension cables with a
sufficient cross section. A cross section which is too small
could cause a considerable drop in performance and an overheating of ma-
chine and cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
A d d i t i o n a l H a n d l e
When using the machine handheld than only with its additional handle.
For mounting, screw it in the thread on the gearbox housing and fix it tightly.
T o o l P r o t e c t i o n
Incorrect handling can cause injury to the operator and damage to the de-
vice. Therefore, always observe the following instructions:
Do not load the machine to such an extent that it comes to a standstill.
Use only original EIBENSTOCK accessories.
Cross section in sq. mm
1,5
20 m
50 m
16
2,5
40 m
80 m