Attaching Your Camera To This Unit - Sony IPT-DS1 Bedienungsanleitung

Attaching your camera
to this unit
Before attaching your camera
Check the following.
The internal memory and "Memory Stick Duo"
ˎ
media have sufficient free space.
The batteries are installed.
ˎ
Make sure the batteries are charged.
ˎ
¦
Notes
For DSC-WX1 users
Before attaching your camera to this unit, check
the flash settings of your camera. You cannot
change the settings after it is attached to this
unit.
How to attach your camera to this unit
This manual describes how to use this unit with the
DSC-TX1.
Align the camera boss with the tripod receptacle,
ˎ
and the multi connector with the multi connector
at the bottom of your camera.
Set your camera perpendicular to the plate.
ˎ
¼
Tips
Make sure that the multi connector of this unit
is fully engaged with the multi connector of your
camera.
10-GB
To remove your camera
Press the MENU button to stop this unit (page 11)
and then lift up the camera with one hand while
supporting the tilt arm with the other.
¦
Notes
When removing the camera, always lift it
ˎ
perpendicular to the tilt arm.
Forcibly removing your camera at an angle or
sliding it sideways may damage it.
When attaching and removing your camera, turn
ˎ
it off.