Attaching The Viewfinder To A Camcorder; Replacing The Viewfinder Shoe - Sony DXF-20W Bedienungsanleitung

i BATT indicator (red)
Indicates that the camcorder battery is
exhausted.
j REC/TALLY indicators (red)
The way in which this red LED indicator
lights or flashes depends on the
specification of the connected camcorder.
k GAIN UP indicator (orange)
Lights when the gain is 3 dB or more.
l SHUTTER indicator (red)
Lights when the camcorder SHUTTER
switch is in the ON position.
m Lock ring
To directly view the screen, turn this ring
counterclockwise, to align the orange
marks on the lock ring and the barrel of the
viewfinder, and remove the eyepiece.
n Tally light
When the TALLY switch (7) is in the
HIGH (high intensity) or LOW (low
intensity) position, this operates in the same
way as the REC/TALLY indicators (q;).
o Barrel
You can rotate this for convenience.
Note
The position of the image may change, as a
result of the earth's magnetic field.
p BRIGHT control
Adjusts the screen brightness. This has no
effect on the signal output from the
camcorder.
q Viewfinder connector
Connect to the VF connector of the
camcorder.
Attaching the
Viewfinder to a
Camcorder
Note
When the viewfinder is attached, do not
leave the camera (or the camcorder) with
the eyepiece facing the sun. Direct sunlight
can enter through the eyepiece, be focused
in the viewfinder and cause fire.
Replacing the Viewfinder
Shoe
When the camcorder has been used with a
viewfinder other than the DXF-20W, it is
first necessary to replace the shoe.
(The following illustrations show the PDW-
F330, but the same applies to the DSR-
450WS/450WSP.)
Note
If you are using the PDW-F350 camcorder,
this operation is not required. The
camcorder was shipped from the factory
with the DXF-20W attached to it.
1
With the supplied hexagonal wrench,
remove the bolts and spring washers,
and detach the viewfinder shoe from
theVF shoe fixing bracket.

Attaching the Viewfinder to a Camcorder

17