Attaching To The Camera - Sony CBK-3610XS Bedienungsanleitung

h Imager block adapter
Adapter (with extension cable) that attaches to the
imager block removed from the camera.
i Receiver
Receiver adapter that connects to the camera
body adapter or an extension cable repeater.
j Tape measure hook attachment hole
Hole for attaching a tape measure hook.
You can remove the tape measure hook from the
camera and it attach it here.
k 24 V OUT connector (Fischer 3-pin)
External power supply output connector.
It outputs the power supply connected to the 24 V
IN connector of the camera body adapter.
It can be connected as an external power supply
for a monitor or lens servo. It can also be used to
input a REC Trigger signal.
Note
For details about Fischer 3-pin connector specifications,
refer to the MPC-3610 Operating Instructions.
l MONITOR OUT connector (BNC type)
Monitor signal output connector. Outputs the
video signal connected to the MONITOR IN
connector of the camera body adapter.
Note
For details about accessory mounting holes, see the
external dimensions drawing at the back of this
document.
18

Attaching to the Camera

Attaching to the Camera
Notes
• The camera must be updated to software version V3.00
or later to use this unit.
Disconnect the unit and reassemble the camera to its
normal state before updating.
• Turn off the camera and wait 30 minutes or longer to
allow it to cool sufficiently before attaching/removing
the unit.
Perform the operation quickly in a dust-free location to
prevent dust and other matter from entering the camera
and adapters.
• Take care not to damage the connectors and parts.
• A data transfer error may occur if there is any dust or
other matter adhering to the adapter connectors. If this
occurs, clean the connector using a cotton swab or
similar tool.
1
Remove the four hex screws on the
bottom and remove the bottom plate
( ), then remove the four hex screws on
1
the front and remove the imager block
from the camera body (
2
1
Short
).
2
Imager block
Bottom plate