Parkside PTSS 1200 D2 Bedienungsanleitung Und Originalbetriebsanleitung Seite 12

2) Adjust the splitting wedge as
described in these operating
instructions. Incorrect spacing,
position and alignment can be the
reason why the splitting wedge does
not effectively prevent a kickback.
3) The splitting wedge must be
positioned in the sawing gap
before it will work. For short cuts,
the splitting wedge is ineffective in
preventing kickback .
4) Do not operate the saw with a bent
splitting wedge. Even a minor fault
can slow down the closing of the
blade guard .
˜ Supplementary notes
Do not use any grinding discs .
Use only saw blades with diameters
corresponding to the label on the saw .
When working with wood or materials
that produce dust hazardous to health,
the appliance must be connected to a
suitable, tested extraction appliance .
Wear a dust mask when sawing wood .
Only use recommended saw blades .
Always wear ear muffs.
Avoid overheating the sawtooth tips .
When sawing plastic, avoid melting the
plastic .
Use the correct saw blade according
to the material to be sawn .
Use only saw blades specified by
the manufacturer which, if intended
for cutting wood or similar materials,
comply with EN 847-1 .
Tools may only be used by trained and
experienced persons who are familiar
with the use of tools .
Circular saw blades with torn bodies
must be taken out of service (repair is
not permitted) .
Use only saw blades that are marked
with a speed equal or higher than the
speed marked on the tool .
Circular saw blades (symbols)
WARNING!
m
Wear protective gloves!
Wear a dust mask!
Wear safety goggles!
Wear ear muffs!
˜ Original accessories/auxiliary
equipment
Use only the accessories and
additional equipment that are specified
in the operating instructions and are
compatible with the appliance .
˜ Vibration and noise reduction
To reduce the impact of noise and
vibration emission, limit the time of
operation, use low-vibration and low-noise
operating modes as well as wear personal
protective equipment .
Take the following points into account to
minimise the vibration and noise exposure
risks:
Only use the product as intended by
its design and these instructions .
Ensure that the product is in good
condition and well maintained .
Use correct accessory tools for the
product and ensure they are in good
condition .
Keep tight grip on the handles/grip
surface .
Maintain this product in accordance
with these instructions and keep it well
lubricated (where appropriate) .
GB/IE/NI 13